CRJ Home Improvement Corp logo CRJ Home Improvement (857) 372-3299

Trim & molding Dedham & Needham

Tight corners. Straight lines.

Baseboard, crown molding, door casing, chair rail and wainscoting. Trim is where a room shows if it was done fast or done right, so we cope the inside corners, scribe to the floor and set every nail below the surface.

CrownCasingBaseBase + shoe

Trim we install

Baseboard & shoeNew base through the house, or a run replaced after new flooring. Shoe molding hides the gap a wavy floor leaves.
Crown moldingSingle-piece or built-up crown, coped on the inside corners, also on top of cabinets.
Door & window casingFlat craftsman casing, colonial casing with back band, or a match to what is already in the house.
Wainscoting & panelsRaised panel, flat panel, beadboard, picture-frame molding and board and batten.
Chair railA rail at chair height, alone or capping wainscoting in a dining room.
RepairsA piece of base kicked loose, casing split by a door stop, a joint that opened up.

Trim in an old house

About seven in ten homes in Dedham and more than half in Needham were built before 1970 (U.S. Census, American Community Survey 2024). In those houses the plaster walls bow, the floors slope and the original casing is often wider and deeper than anything at the lumber yard today.

That changes the job. Baseboard gets scribed to the floor instead of caulked, casing gets a back band to match the depth of the old one, and crown goes up on a wall that is not straight, so it gets shimmed or set on blocking. It takes longer than new construction, and it is the reason the new trim looks like it was always there.

Trim questions

MDF or poplar for baseboards?

Both paint well. MDF is cheaper and very straight, but it swells if it gets wet, so we use poplar or PVC where floors get mopped a lot or near exterior doors. For crown and casing in dry rooms, MDF is a fine choice.

Can you match the old trim in my house?

Usually yes. Many older casings and crowns can be rebuilt by stacking two or three stock moldings. We take a piece or a photo of the profile at the estimate and show you the closest match before cutting anything.

Why cope inside corners instead of mitering?

A coped joint follows the face of the molding, so it stays tight when the house moves with the seasons. A mitered inside corner tends to open up. We cope baseboard and crown on inside corners.

Does new trim need a permit?

No. Trim is finish work, and the Massachusetts building code does not require a permit for it (780 CMR 105.2).

Is the house before 1978? Does that matter?

Yes. Cutting or sanding old painted trim in a home built before 1978 can release lead dust, and Massachusetts has lead-safe renovation rules for that work. Tell us the year the house was built when you call, and we plan the job around it.

Free estimate. We come and measure.

Tell us the town and what you want built or fixed. A photo or two of the room helps us show up with the right idea.

(857) 372-3299 Text us

Calls and texts in English or Portuguese.

Best way to reach you